Furuno FSV-84 User Manual download pdf (Page 38)

2-10

Positioning guide pins

Guide pins of the connector identify the mating receptacle. They are;

• Guide pin A (Large): 1

• Guide pin B (Small): 1

Use the tool (Type: 10-910-0179-0) shown below to position guide pins.

Guide Pin A (Large)

Connector

Guide Pin

CN-A101

Guide Pin B (Small)

Tool

Guide pin insertion tool (notch in head)

2.4.2 Power cable

Attach the NCS-253-P connector to the power cable (DPYCY-1.5 or equivalent) and connect

to the CN-A110 on the rear of the processor unit.

Conductor

S = 1.5 mm

= 1.56 mm

Vinyl

sheath

Armor

Cable DPYCY-1.5

Armor Vinyl sheath

Taping

Solder lead wire to armor and

connect it to #1 pin of connector.

Use cable DPYCY-1.5

(Japan standard cable)

or equivalent cable.

Slip on heat-shrink tubing

or elastic tubing and heat.

Armor

Vinyl sheath

Taping

Solder lead wire to armor and

connect it to #1 pin of connector.

Assembling connector NCS-253-P

2.4.3 Cable from monitor unit

Connect the cable 10S2074 (10 m) or 10S2075 (30 m) from the monitor unit to the

connectors in the processor unit as shown below.

38P connector: CN-A103 (For the optional sub-monitor display, CN-A108)

D-sub 25 pin: CN-A102 (For the optional sub-monitor display, CN-A107)

D-sub 15 pin: CN-A104 (For the optional sub-monitor display, CN-A109)

2.4.4 Cable from control unit

For blackbox configuration, attach the cable (10S2076) from the control unit (FSV-8401) to

CN-A103 on CONE Board (10P6905) in the processor unit, passing it through the cable

clamp in the processor unit.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 94 95

Comments to this Manuals

No comments

Furuno FSV-84 User Manual Page 38

Comments to this Manuals

Related products and manuals for Air equipment Furuno FSV-84