Furuno FSV-84 User Manual download pdf (Page 20)

1-12

Control unit cover

Previous cable hole

Screw

M4x8 (8 pcs.)

Clamp

Screw (M4x12)

Fasten the cable with the clamp here.

Nut

Spring washer

Flat washer

Control unit, cover removed

Passing the cable through the bottom of the control unit (for permanent mounting)

For permanent mounting methods (2) and (3), the control cable can be passed through the

bottom of the control unit as follows:

1. Unfasten eight screws (M4) to

remove the cover from the bottom

of the control unit.

2. Unscrew two screws (M4×10) to

remove the cable clamp.

3. Disconnect two connectors J1 and

J2 from the circuit board.

4. Attach the control cable to the

control unit cover with the cable

clamp (removed at step 2), two

flat head screws (M4), flat

washers, spring washers and nuts

(hardware: supplied).

5. Re-connect two connectors

disconnected at step 3.

6. Fasten eight screws to attach the

control unit cover.

7. Attach the connector seal (supplied) to the hole at the rear of the control unit.

8. Drill a hole of 30 mm in diameter to pass the cable from the bottom of the control unit

through the tabletop

9. Attach the connector seal (supplied) to the hole at the bottom of the control unit when the

above modification is not done.

10. Fix the control unit referring to (2) or (3) on the previous page.

Cable

Without KB fixing plate

With KB fixing plate

Hole for leading in cable

FSV-

Control unit, side view

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 94 95

Comments to this Manuals

No comments

Furuno FSV-84 User Manual Page 20

Comments to this Manuals

Related products and manuals for Air equipment Furuno FSV-84