Furuno GP-150 User Manual download pdf (Page 34)

5. STARTING FOR DESTINATION

5-2

Flag

mark

Figure 5-4 Single destination set by cursor

Setting multiple destinations

1) Press GOTO and 1.

2) Place the cursor on the location desired

for waypoint.

3) Press the NU/CU ENT key.

4) Repeat steps 2 and 3 to enter other points.

Waypoints are connected with a line.

5) Press the NU/CU ENT key to finish. The

route number entry display appears as

shown in Figure 5-5. If no route number

appears or you want to change the route

number shown, go to step 6 to enter route

number. To register the route under the

number shown, go to step 8.

Enter route number

ENT:Enter MENU: Escape

0 1

Figure 5-5

6) Key in route number.

7) Press the NU/CU ENT key. Waypoints are

marked with flags and are connected with

a dashed line.

If the route number entered already exists

the message shown in Figure 5-6

appears.

Overwriting ?

ENT:Yes MENU:No

Figure 5-6

8) Press the NU/CU ENT key.

The waypoints do not have waypoint

numbers, however you can attach

waypoint numbers by doing the following.

1

Press WPT RTE and 6 to display the

route list.

2

Press or to select route number

entered.

3

Press .

4

Enter waypoint number, in three digits.

5

Press . If the waypoint number already

exists the message shown in Figure 5-7

appears.

This waypoint already exists

Are you sure to change ?

ENT:Yes MENU:No

Figure 5-7

6

Press the NU/CU ENT key. The waypoint

entered here replaces previously entered

waypoint.

Note: To cancel replacement of waypoint,

press the MENU ESC key at step 6.

7

Repeat steps

4

and

5

to enter other

waypoint numbers.

8

Press the MENU ESC key twice to finish.

When destination is cancelled, dashed lines

are erased but flags remain on the screen.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 96 97

Comments to this Manuals

No comments