Furuno GP-150 User Manual download pdf (Page 33)

5-1

5. STARTING FOR

DESTINATION

5.1 Setting Destination

There are four ways by which you can set

destination:

• By cursor

• By MOB position or event position

• By waypoint, and

• By route.

Note: Previous destination is cancelled

whenever a destination is set.

Setting destination by cursor

Using the cursor you may set a destination

consisting of 30 points. When all 30 points

are entered, the GP-150 automatically

disables further entry.

Setting single destination

1) Press the GOTO key. The menu shown in

Figure 5-2 appears.

1. Cursor

2. MOB/Event Position

3. Waypoint List

4. Route List

5. Cancel

GOTO Setting

1. Cursor

ENT : Enter

: Cursor

MENU : Escape

Figure 5-2 GOTO setting menu

2) Press 1 to select Cursor. The display

shown in Figure 5-3 appears.

Place cursor on desired location

Press ENT twice to finish

ENT:Enter CLR:Clear MENU:Escape

Figure 5-3

If the display in use is Highway,

Navigation or Data display, the Plotter 2

display is automatically selected.

3) Place the cursor on the location desired

for destination.

4) Press the NU/CU ENT key.

Note: To clear selection, press the CLEAR

key.

5) Press the NU/CU ENT key to finish.

Control is returned to the display mode in

use before you set destination. A dashed

line connects own ship and the

destination, which is marked with a flag,

as shown in Figure 5-4.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 96 97

Comments to this Manuals

No comments