Furuno GP-36 User Manual download pdf (Page 19)

2-1

2. PLOTTER DISPLAY OVERVIEW

2.1 Enlarging/Shrinking the

Display Range

You may increase or decrease the display

range on the plotter and highway displays.

The horizontal range in the plotter display

is available among .02 (40 yd), .05 (101 yd),

0.1 (202 yd), 0.2 (405 yd), 0.5, 1, 2, 5, 10,

20, 40, 80, 160 and 320 nautical miles.

(Nautical mile is the default unit of display

range. Display range may also be shown

in kilometers or miles. Ranges shorter than

the value 0.5 are also shown in yards or

meters.) The horizontal range in the high-

way display is available among 0.2, 0.4, 0.8,

1, 2, 4, 8 and 16 nautical miles.

1. Press the [MENU] key. The zoom, ship

centering window appears.

Figure 2-1 Zoom, ship centering window

Note: The prompt “SHIP TO CENTER?”

does not appear when the highway

display mode is active.

2. Press the [ENT] key. The zoom window

appears.

Figure 2-2 Zoom window

3. Press ▲ (increase) or ▼ (decrease) to

select range desired.

4. Press the [ENT] key to finish.

2.2 Shifting the Cursor

Use the cursor pad to shift the cursor. The

cursor moves in the direction of the arrow

or diagonal pressed on the cursor pad.

Cursor state and data

Cursor state determines what data is shown

on the display.

Cursor turned on

Cursor position is displayed in latitude and

longitude or TDs (depending on menu set-

ting) at the bottom of the plotter display

when the cursor is on. The range and bear-

ing from own ship to the cursor appear at

the left-hand side of the display.

Figure 2-3 Data displayed on the plotter

display when the cursor in on

Cursor turned off

The cursor is erased when there is no cur-

sor pad operation for about six seconds.

Ship’s position, speed and course appear

at the left side of the plotter display when

the cursor is off.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 80 81

Comments to this Manuals

No comments