Furuno Network Sounder DFF3 User Manual download pdf (Page 21)

2. WIRING

4. Connect the transducer cable to the WAGO connector, following the instructions in the figure

below and the interconnection diagram. (The opener for the WAGO connector is attached in-

side the equipment. See the figure above.)

5. Unfasten the two screws labeled Screw A in the figure below.

6. Loosen the two screws labeled Screw B and slide cable clamp upward.

7. Pass the transducer cables through the cable entrance and connect their WAGO connectors

to respective terminals inside the equipment.

8. Slide the cable clamp downward and tighten screws B and A in that order to fasten the cable

clamp.

1. Twist conductors.

2. Insert opener as directed and press it down.

3. Insert core to hole.

4. Release opener.

5. Pull the core to make sure it is correctly inserted.

Opener (attached inside the equipment)

Core

Twist.

Push

Screw A

Screw B

Cable

clamp

Clamping

plate

Transducer cable

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

No comments

Furuno Network Sounder DFF3 User Manual Page 21