Furuno GP-1850DF User Manual download pdf (Page 38)

3-12

6. Remount the cover assembly.

Note: Confirm that the following parts are attached:

• Inside of the cover: Shield gaskets, GN gasket (See Figure 3-17.)

• On ANLG Board: Connector gasket (See Figure 3-15.)

GN gasket

Shield gaskets

Figure 3-17 Inside of the cover

7. Tighten nuts to torque shown below and in the order shown in Figure 3-18.

No. 1 through No. 5 : 7.5 - 8 kgf/cm

No. 6 : 14 -16 kgf/cm

ANT XDR

TEMP/SPD

DGPS

NMEA

+ GND

1 3

12 - 24

VDC

Figure 3-18 Display unit, rear view

8. Tighten ten binding screws (M3 x 10) fixing the cover to torque of 7.5-8 kgf/cm.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 62 63

No comments

Furuno GP-1850DF User Manual Page 38