Furuno CSH-24F User Manual download pdf (Page 13)

Installing stays (anti-vibration

measure)

Install stays from the top of the hull unit to

the ship’s hull. The stays should be angle

iron with a size of 75 x 75 x 9 mm or more

and at least two pieces should be used; one

each to ship’s bow and stern directions. In-

stall if possible, two more stays in ship’s

transverse direction.

Do not install the stays as shown below. Vibration-resistance effect is reduced since vibration is

applied to the stays as rotation force. Install them horizontally.

Figure 3-8 Proper and wrong installation of stay

Fastening receiver unit to hull unit

Fasten the receiver unit to the left side of the hull unit

as shown at right.

A transducer cable protection cover has been fitted

where the receiver unit is to be fastened to the hull unit.

Remove it when mounting the receiver unit.

Raise/Lower

Control Box

(Attached at

factory)

Receiver

Unit

Figure 3-7 Proper installation of stays

90°

Proper installation

Figure 3-9 Mounting of receiver unit

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 97 98

No comments

Furuno CSH-24F User Manual Page 13