Furuno GP-30/35 User Manual download pdf (Page 33)

7-2

8. Select AUTO or MANU. AUTO uses

ship’s average speed to calculate time-

to-go; MANU is for manual entry of

speed.

9. Press the [ENT] key. If you selected

AUTO no further operation is necessary.

For MANU, press the [ENT] key again.

Enter speed with the Cursor Pad and

press the [ENT] key.

Figure 7-5 shows what the display might

look like using Route-01 for an example.

CALCULATION

MODE: ROUTE

NO. : 01 (WYPTS: 4)

KOBE → OSAKA

SPD : AUTO

TTG: 1H39M ETA: ---

RNG: 9.06 nm BRG: --- °

Time-to-Go

Estimated Time of Arrival

Range Bearing

Figure 7-5 Typical calculation

display (route)

7.2 DGPS Setup

The GP-35 is equipped with a DGPS bea-

con receiver, and the GP-30 may be con-

nected to a DGPS beacon receiver. Set up to

receive the DGPS beacon signal as follows:

1. Press the [MENU] key twice.

2. Select D-GPS and press the [ENT] key.

D-GPS SETUP

BEACON : EXT

STATION : MANUAL

RATE : 200 BPS

FREQ : 310.0 kHz

BEACON STATION : GOOD

D-GPS DATA : GOOD

SIG. S : 00.0 dB SNR: 00.0 dB

Figure 7-6 D-GPS SETUP menu

3. Press the [ENT] key.

4. Select INT for internal DGPS beacon re-

ceiver; EXT for external DGPS beacon

receiver. Press the [ENT] key.

5. The cursor is on the STATION line. Press

the [ENT] key.

6. Choose DGPS beacon station selection

method: AUTO 1, AUTO 2 or

MANUAL.

AUTO 1, AUTO 2: Automatically

search for nearest DGPS beacon station.

The GP-35 always searches for nearest

DPGS beacon station.

MANUAL: Manually enter DGPS bea-

con station specifications (on the RATE

and FREQ lines), referring to the DGPS

reference station list in the Appendix.

7. If you selected AUTO, no further opera-

tion is necessary; you may press the

[MENU] key twice to finish. For

MANUAL, the cursor is now on the

RATE line. Press the [ENT] key.

8. Select the transmission rate of the DGPS

beacon station nearest you, among 50,

100 or 200 bps. Press the [ENT] key.

9. The cursor is now on the FREQ line.

Press the [ENT] key.

10.Enter nearest DGPS beacon station’s fre-

quency with the Cursor Pad.

11.Press the [ENT] key.

12.Press the [MENU] key twice to finish.

7.3 Bearing Reference

Ship's course and bearing to a waypoint may

be displayed in true or magnetic bearing.

Magnetic bearing is true bearing plus (or mi-

nus) earth’s magnetic deviation.

The default setting displays magnetic bear-

ings.

1. Press the [MENU] key twice.

2. Select PLOTTER.

3. Press the [ENT] key.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 66 67

Comments to this Manuals

No comments