Furuno 1932 MARK-2 User Manual

1-32. Lay the scanner unit on the mounting plat-form, orienting it as shown in Figure 1-6.STERNBOWFigure 1-6 Scanner unit (Shown: XN12A)CAUTIONDo not

1-4Fixing holes inside szcanner unitThis method requires removal of the RF unitin the scanner unit to access inside fixingholes. Use hex head bolts

2-12.1 Connecting the Signal CableOnly the signal cable runs from the displayunit to the scanner unit. In order to minimizethe chance of picking

2-27. Unfasten four screws shown in the figurebelow.Four screwsFigure 2-5 Scanner unit chassis,cover opened8. Pass the signal cable through the cable

2-3Connection procedure1. Connect the power cable to the powercable connector on the rear of the displayunit.2. Connect the signal cable to connector

2-42.4 Exchange of Fuse for 24/32V Power SupplyThe power cable comes with a 10A fuse inits the fuse its holder. This fuse is for use witha 12V D

3-13. ADJUSTMENTThis section covers adjustment of the radarafter installation. You will need to• adjust tune/video amplifier level• enter antenna hei

3-23.4 Aligning Heading (Adjustment sector: 0~359.90)You have mounted the scanner unit facingstraight ahead in the direction of the bow.Therefore

3-3[ Sweep Timing Adjustment ]Use omnipad to straighten target and press ENTER key.Correction 0.000 nm<Press MENU for inst setup>Figure 3-5

3-43.9 Checking Magnetron Heater VoltageMagnetron heater voltage is formed on theMD Board of the scanner unit, and ispreadjusted at the factory f

C 9-52, Ashihara-cho, Nishinomiya, Japan Telephone: 0798-65-2111 Telefax: 0798-65-4200 Your Local Agent/Dealer All rights re

4-14. INSTALLATION OF ARP-10 (OPTION)NOTICEThis option is not available with 48 rpm scanner unit.4.1 Necessary PartsemaNepyT.oNedoCytQdraoB01-PRA7009

iSAFETY INSTRUCTIONSWARNINGRadio Frequency Radiation HazardThe radar scanner emits electromagnetic radio frequency (RF) energy which can beharmful, p

iiCAUTIONCAUTIONObserve the following compass safedistances to prevent deviation of amagnetic compass:Ground the equipment toprevent electrical shock

iiiTABLE OF CONTENTSSYSTEM CONFIGURATION ... ivEQUIPMENTS LIST ...

ivSYSTEM CONFIGURATIONRDP-118Auto PlotterARP-10(24 rpm only)NavigationdeviceIEC 61162* (In/Out)IEC 61162* (In/Out)Video SounderGyro-compassGyro Conve

vEQUIPMENT LISTSStandard SupplyemaNepyT.oNedoCytQskrameRtinUrennacS460-0700-BSR-A01NX—tceleSenompr42,2M2391roF460-3700-BSR-A01NX— mpr84,2M2391roF950-

1-11. MOUNTING1.1 Mounting Methods for Scanner Unit• The scanner unit is generally installed ei-ther on top of the wheelhouse or on theradar mas

1-21.3 Fastening the Radiator to the Radiator BracketFor your reference, scanner installation ma-terials list appears in the packing lists at th