Furuno FS-1570 User Manual download pdf (Page 145)

9 NBDP PREPARATIONS

9-7

9.4.2 Editing/Deleting user channels

1. Press function key [F5] and then the [4] key.

2. Press the [↑] or [↓] key to choose channel from the Channel List.

3. Press [→] and [↓] keys to choose Change and press the [Enter] key.

4. Do one of the following:

Edit channel: Use [↑], [↓] and the [Backspace] key to make modifications.

Delete channel: Erase channel number with the [Backspace] key.

5. Press the [Enter] key twice.

6. Press the [Esc] key.

9.5 Scan Channel Groups

The NBDP Terminal Unit can automatically control radio equipment through channel

scanning. The radio equipment scans a number of channels (according to your selection),

stopping when your own ID code is detected in an incoming signal. The transmitter is then

tuned to the corresponding transmitter frequency, the communication link is established and

the traffic is automatically exchanged. Scanning resumes once the link is disconnected.

You may store up to 10 scan groups, 20 channels per group. Note that scanning is only

possible in the ARQ and FEC modes.

9.5.1 Registering scan channel groups

You may register ITU and user scan channels as follows*

1. Press the function key [F5] followed by the [3] key to display the Scan Entry screen.

Create

Change

Scan Entry

Scanning Group List

Scanning Set Up

Group Name :

Ch Dwell Time : 4.5 sec (2.7-4.5 sec)

Mode : AUTO ARQ FEC

Auto Search : OFF ON

No Channel Rx Freq Tx Freq Pass/Scan

Pass/Scan

▼

Scan entry screen

2. If Create is not underlined, press [→], [↑] and the [Enter] key to underline it.

3. Press the [↓] key to choose Group Name. Enter suitable group name.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 214 215

No comments

Furuno FS-1570 User Manual Page 145