Furuno FM-4000 User Manual Page 53

  • Download
  • Add to my manuals
  • Print
  • Page
    / 84
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 52
Page 53FM-4000
11.9 POSITION SEND
The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to
another vessel. Your vessel must have an operating GPS receiver connected
to the FM-4000 to send your position.
NOTE
To transmit a Position Send call, you must set up the FM-4000 DSC
Individual / Position Call Directory with the name of the vessel(s) or
person and the MMSI of the DSC radio you wish to send your position
to. To setup this directory, see section “11.5.1 Setting up the Individual
/ Position Call Directory.”
11.9.1 Setting up a Position Send Ringer
The FM-4000 has the capability to turn off the Position Send ringer as follows.
1. Press and hold down the
[
CALL
(
MENU
)]
key
until the “
Radio SetupRadio Setup
Radio SetupRadio Setup
Radio Setup” menu appears.
2. Turn the CHANNEL selector knob to select the
DSC SetupDSC Setup
DSC SetupDSC Setup
DSC Setup” menu.
3. Press the
[
ENT
]
key, then use the CHANNEL
selector knob to select “
DSC BeepDSC Beep
DSC BeepDSC Beep
DSC Beep.”
4. Press the
[
ENT
]
key, then use the CHANNEL
selector knob to select “
Position ReportPosition Report
Position ReportPosition Report
Position Report.”
5. Press the
[
ENT
]
key, then select “
OffOff
OffOff
Off” with the
CHANNEL selector knob.
6. Press the
[
ENT
]
key to store the selected set-
ting.
7. Press the
[
CLR
]
key twice to return to the “
RadioRadio
RadioRadio
Radio
SetupSetup
SetupSetup
Setup” menu, then press the
[
CLR
]
key again to re-
turn to radio operation.
To enable the ringer tone, select “
OnOn
OnOn
On” at step “6” in this procedure.
11.9.2 Transmitting a DSC Position Send Call
Using Pre-Programmed Vessel
1. Press the
[
CALL
(
MENU
)]
key to show the “
DSCDSC
DSCDSC
DSC
Call MenuCall Menu
Call MenuCall Menu
Call Menu.”
2. Turn the CHANNEL selector knob to select
Pos ReportPos Report
Pos ReportPos Report
Pos Report.”
Page view 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 83 84

Comments to this Manuals

No comments