Furuno ETR-30N User Manual download pdf (Page 32)

2.3.2 ETR-30N and ETR-6/10N

When installing an ETR-30N and an ETR-6/10N, the ETR-6/10N’s host name of SOUNDER

cannot be changed. For this reason, the set the HOST NAME control of the ETR-30N to “1”

and its host name to “SOUNDER1.” Turn the ETR-30N off and on again after setting the

HOST NAME control to register settings.

1. Set tappings of ETR-30N as in paragraph 2.2.1.

2. Set the HOST NAME control of the ETR-30N to “1” and turn on the power.

3. As shown in paragraph 2.2.2, set sounder source for “SOUNDER1” on the NavNet

display unit as below.

a) Rotate the [ENTER] knob to choose SOUNDER SOURCE.

b) Press the EDIT soft key.

c) Enter SOUNDER1 with the numeric keys.

d) Press the RETURN soft key.

Note: The HOST NAME control setting and sounder source name (numeric) must agree.

(See the table below.) If not, the equipment cannot function.

4. Set the ETR-30N as shown in paragraph 2.2.3.

HOST NAME

control setting

on ETR-30N

SOUNDER SOURCE set

on NavNet display unit

1 SOUNDER1

Note: The host name and frequency on the ETR-6/10N are fixed to SOUNDER and 50/200

kHz, respectively.

HUB

NavNet

Display Unit 1

NavNet

Display Unit 2

NavNet

Display Unit 3

Change sounder

source to "SOUNDER1."

ETR-30N

HOST NAME: 1

ETR-6/10N

Turn power

off to set.

Set up

transducer.

Installation with ETR-30N and ETR-6/10N

If the ETR-6/10N is generating interference, use the interference rejector on the NavNet

display unit to reject it. If that does not work, contact your dealer for advice.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

No comments

Furuno ETR-30N User Manual Page 32