Furuno GP-30 User Manual download pdf (Page 2)

Registering Waypoints

A waypoint can be entered four ways. Be-

low is the procedure for entry by the cursor.

1. Operate the Cursor Pad to place the cur-

sor on the location you want to make a

waypoint.

2. Press the [ENT] key.

ENTER A NEW WYPT NAME.

0 0 1 — — — ?

( 001: DEFAULT NAME )

Quit : [MENU]

CURSOR POS. → WYPT

3. Press the [ENT] key.

NAME: KOBE

34°44.000’N MARK

135°21.000’E x

12—DEC—97 11:25

Exit?

4. Place the cursor under “MARK”.

5. Press the [ENT] key.

6. Press ▲ or ▼ to select the mark desired.

7. Press the [ENT] key.

8. Select “Exit?” and then press the [ENT]

key.

Registering Routes

1. Press the [MENU] key twice.

2. Select “ROUTES”.

3. Press the [ENT] key.

4. Press the [ENT] key.

5. Press the [ENT] key, select route

waypoint and press the [ENT] key.

6. Repeat steps 5 to enter other waypoints

on the route.

7. Select “Exit?”.

8. Press the [ENT] key to register.

Setting, Cancelling Destination

Destination can be set three ways. Below is

the method for setting destination by the

cursor.

To set destination;

1. Press the [GOTO] key.

2. Select “CURSOR?”.

3. Press the [ENT] key.

4. Place the cursor on position to set as des-

tination.

5. Press the [ENT] key.

To cancel destination;

1. Press the [GOTO] key.

2. Select “OFF?”.

3. Press the [ENT] key.

Setting the Arrival Alarm

1. Press the [MENU] key twice.

2. Select “ALARMS”.

3. Press the [ENT] key.

4. Press the [ENT] key.

5. Select “ARV”.

6. Press the [ENT] key.

7. Press the [ENT] key and enter arrival

alarm range.

8. Press the [ENT] key.

9. Press the [MENU] key.

PUB.NO.OSE-43840-D

(9801,DAMI) GP-30/35

1 2

Comments to this Manuals

No comments